Complete Monster Bash - Full Works

[Joules]

Another quick point, it would appear that Frank's arms need adjusting. As far as I'm aware, when he's "lying down" his arms should be flat with table.

Good job though!

Cheers,

Goz

Hi there,

I used a variety of fonts. Arial as a base matched my warranty stickers best but I often had to change the spacing and height. The fuse list was as per stock.

I am less concerned over the serials now but didn't want them appearing on another MB.

I have seen Franks arms in many different positions but never flat with the table?

Cheers,

Joules

 

[newdos]

cracking job mate looks amazing - better than new!!!

Cheers Kev

 

[Deleted member 2463]

Amazing, How's the mirco playfield holding up? Was there any issues with it compared to the stock playfield? Everything in the right place? (Holy thread resurrection batman!

Thanks,
Neil

 

[Joules]

Amazing, How's the mirco playfield holding up? Was there any issues with it compared to the stock playfield? Everything in the right place? (Holy thread resurrection batman!

Thanks,
Neil

Hi Neil,

Best discuss this further via pm.

Joules

 

[Monkeyboypaul]

Hi Neil,

Best discuss this further via pm.

Joules

I'd be interested in any feedback on the Mirco too, given I recently installed one in AFM.

Posted a query on Pinside, but it didn't tell me anything particularly useful.

https://pinside.com/pinball/forum/t...ts-the-wear-situation-after-a-couple-of-years

 

[Joules]

I did suffer some issues but received a good service in getting things sorted. I was advised my issue was an adhesion problem localised to my PF. Open forum can go wild with these posts so if you want more info specific to my issue via PM only.

Thanks