Wanted WPC DMD driver board

[bethamari]

Hi all,

Does anyone have a spare working DMD board they’d be willing to sell? Ones of ours has a fault and is causing the DMD display to flicker and has gassed the last DMD. Tried a board from another machine and it worked great so just need to replace/fix the board.

Thanks!

 

[stoptap]

Probably needs the High Voltage section rebuilding. Only £10 from Andy ( https://pinparts.co.uk/products/williams-bally-wpc-wpc-95-dmd-hv-rebuild-kit ).
I’d happily replace the components for you. I’ve done more of these than I care to remember.

 

[stoptap]

Just seen your other thread with the problem and Andy mentions changing the caps. If you order them at the same time I would do the lot for you.

 

[bethamari]

Ace cheers! Will take you up on that and get an order in. Do you know much about the main driver board too? Half of our back box GI is out, we’ve replaced the J120 connector but not the pins on the board yet - but know that could be the reason behind it too.

 

[stoptap]

Ace cheers! Will take you up on that and get an order in. Do you know much about the main driver board too? Half of our back box GI is out, we’ve replaced the J120 connector but not the pins on the board yet - but know that could be the reason behind it too.

If you bring it round I will replace the header pins for you.

 

[stoptap]

Ace cheers! Will take you up on that and get an order in. Do you know much about the main driver board too? Half of our back box GI is out, we’ve replaced the J120 connector but not the pins on the board yet - but know that could be the reason behind it too.

Make sure you order the WPC kit and not the WPC-95 kit.

 

[bethamari]

Make sure you order the WPC kit and not the WPC-95 kit.

Ta! Would you mind linking to the right capacitors too please?

 

[stoptap]

Ta! Would you mind linking to the right capacitors too please?

I’m not sure which they are. Email Andy from Pinballmania, he will tell you which ones to order.

 

[BigIan]

Although Andy is on hols for a week

http://www.pinballinfo.com/community/threads/pinparts-taking-a-time-out.39005/#post-245198