Just realised why I'm getting lots of rejected shots from the lower right flipper on my TFTC, the bendy part of the scoop is missing completely.
Anyone have one or able to find one?
Cheers
Anyone have one or able to find one?
Cheers
Pinball info
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Found it! TFTC scoop bracket
- Thread starter windoesnot
- Start date
There is a TFTC for parts on this site
http://www.pin-games.se/main/special.htm
http://www.pin-games.se/main/special.htm
OP
OP
I'll make an enquiry but that site hasn't been updated for years.
The scoop design for GnR is the same bar the mounting hole points which shouldn't be an issue so might try to source one of these. Either that or find a way to get a new bendy part of the scoop bracket and have it welded on.
The scoop design for GnR is the same bar the mounting hole points which shouldn't be an issue so might try to source one of these. Either that or find a way to get a new bendy part of the scoop bracket and have it welded on.
What is the part number ? I may have one here.
OP
OP
The one for TFTC: 515-5899-00 (as stated in the manual, power scoop weld assembly)
The one for GnR: 500-5809-00 (http://www.marcospecialties.com/pinball-parts/500-5809-00)
Thanks Dave
The one for GnR: 500-5809-00 (http://www.marcospecialties.com/pinball-parts/500-5809-00)
Thanks Dave
Part number seems familiar, but I don't have it, so must've sold it.
Only have the 535-7329-01 for the later games.
Maybe send a photo and can look through my used parts ?
Only have the 535-7329-01 for the later games.
Maybe send a photo and can look through my used parts ?
OP
OP
I'll take it out tonight and see