Wanted Some help rivetting 4 ramp flaps

[Monkeyboypaul]

Hello,

I've got 3 ramps + the shooter lane on my AFM restore which need the stainless steel ramp flaps fitting to them.

I've got the Pinbits rivet kit where you use a hammer and a nylon tube, but they just work loose after a while.

Would anyone be willing to offer up their riveting press skills and do them for me?

I'm based near York but will be travelling to Birmingham city centre (Mailbox / New Street) this Thursday 11th. And again next week Tues/Weds/Thurs.

Xmas Beer vouchers available.

Cheers.

 

[replicas]

I can do them for you Paul.
You know where I am if you can fit it in.

 

[PeteB]

You may find this helpful. Just skip to 2:34 to avoid the nonsense intro:

 

[Monkeyboypaul]

I can do them for you Paul.
You know where I am if you can fit it in.

Cheers Daz. I've had an offer for help, but i absolutely know who and where you are if it falls through, very much appreciated

 

[replicas]

Anytime buddy.

 

[Joules]

You may find this helpful. Just skip to 2:34 to avoid the nonsense intro:

Interesting that he dislikes the roll over rivet punch? I had bought a set but not yet used them. He favors a centre punch and then punch?

 

[Paul]

Hammer punches have been proved to break ramps on multiple occasions as there's no control over the pressure...