Wanted Semi-Tubular Rivets for Stand-Up Target

[Nedreud]

I know there was a group buy-in last year headed up by @Paul with @Calimori and @mufcmufc, to buy US-sized rivet dies, presses and rivets.

Shortly I'm going to need some rivets to redo the joined-up stand-up targets in my GOLD BALL as the connecting plastic has snapped (going to have to make a reproduction plastic):

Once I've found out what length is required (I'm assuming 1/8" diameter) would anyone be willing to sell me half a dozen? I only actually need two for the outer targets (the middle gold "button" sits through a hole in the plastic) but handy to have a couple of spares in case I mess them up.

 

[mufcmufc]

I don't presently have any, not sure if anyone bought the rivets. Might be able to get hold of some though

 

[Nedreud]

Thanks @mufcmufc. I'm sure someone will have a few knocking around but I just noticed that Ponball Mania has several on "the long list of parts":

07-6688-19N Roll-Over Rivet 1/2" x 9/32" nickel
07-6688-21N Roll-Over Rivet 1/8" x 9/32"
07-6688-27 Rivet 1/8" Diameter x 9/16"
HW93 Rivet 1/8" x 7/32"
HW94 Rivet 1/8" x 9/32"

Hey, @pinballmania! Do you have any of these in stock?

 

[pinballmania]

I keep a small amount for repair work, probably will have what you need. Let me know the size and material required.