Wanted Parts Wanted: Fish Tales

[Nige4554]

I have a few spare bits off my renovated Fish Tales and looking for a couple of parts if anyone has them
Wanted
Bolts for the reel to go onto the front panel.
1 flipper spring.
1 spinner for left ramp could be the wire going under the table as the spinner is not sitting straight and wont allow the ball up the left outa run.
I am going to the US in December so will get new if non available.

Parts to give away
Several plastics not a full set
CPU board which was replaced it works but good for parts
top glass (when I pick up my non reflective from Neil

 

[Nige4554]

Any help appreciated. near end of renovation of Fish Tales, still no joy with bolts for reel or solution for the left spinner, I ordered from US and have put it in a safe place lol, sure it will turn up, in the mean time to embark on re-decal, messy job and need to allocate time to get it done. I have seen one fault which is the left lane is not recognised to get the tale told. Any clues?
3 questions
Left Spinner or mechanism ? spinner is not sitting parallel therefor not allowing flow of the ball through it
which sensor making left loop allows Tale Told to be recognised
Where can I get 4 bolts from that fit the reel to the body
thanks