Looking for ball guide wire 12-6466-5

[Roger440]

As per title i need one of these for my Indy500.

I can find it in the USA, but shipping is killing it for a $1.99 part

Any good ideas where i can get one over here?

Suggestions greatly appreciated.

 

[BigIan]

Get suitable grade piano wire and bend one yourself

 

[Roger440]

Get suitable grade piano wire and bend one yourself

Good idea. Was thinking about stainless welding wire/rods today. Im assuming these are glued in?

 

[replicas]

Have you a picture of what you are looking for.

 

[stoptap]

Have you a picture of what you are looking for.

 

[stoptap]

By the way, I would use stainless steel TIG welding rod to make one. Matches the original guides perfectly.

https://www.weldright.co.uk/tig-fil...quantity_of_rods-10x_rods/29-size_of_rod-24mm

 

[Roger440]

By the way, I would use stainless steel TIG welding rod to make one. Matches the original guides perfectly.

https://www.weldright.co.uk/tig-fil...quantity_of_rods-10x_rods/29-size_of_rod-24mm

Good info. Only have 1 & 1.6mm in stock. Good to know 2.4 matches the original as ive nothing to compare it to.

 

[stoptap]

Good info. Only have 1 & 1.6mm in stock. Good to know 2.4 matches the original as ive nothing to compare it to.

https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.co.uk/ulk/itm/152569298129

 

[Chris P]

Have you tried using a coat hanger? Just cut and bend it, I did that for a similar looking part on F14, worked a treat.

 

[replicas]

I have certain ball guide from parted out games. I might have the size you require.
Measure between the legs of the guide or the holes in the playfields where the guide goes and I will see if I have one.
D.

 

[Roger440]

Its 1 1/4 inches.

 

[replicas]

Sorry it's been a while. I have found some but smallest is 21/2 inch so PM me and I will send you a couple and you can make what you need out of them.
D.