Jersey Jack - PSU jump starter lead.

[Pick Holder]

Okay - I have made these in the past before for customers.

Sometimes a JJP machine wont start up and needs jump starting.

This stays permanently connected between the ATX power supply and the motherboard. It has a button to push when a jump start is needed.

I could extend the leads so the button could be left near the coin door.

What do you guys think?

Is this a needed mod?

 

[Pick Holder]

 

[johnh]

Only happened to me once (in 18 months of owning two JJP games) , but it's a pain in arris to get the monitor out the way, disconnect the LED strip, remove the cover and shove a screwdriver in hoping you get the right pins. So if this remove all of those steps, I'd be in for two.

 

[Pick Holder]

Only happened to me once (in 18 months of owning two JJP games) , but it's a pain in arris to get the monitor out the way, disconnect the LED strip, remove the cover and shove a screwdriver in hoping you get the right pins. So if this remove all of those steps, I'd be in for two.

So would you think longer leads so the push button could be near the coin door?

 

[johnh]

Either that or make it long enough to hang just below the monitor so all you'd have to do is take the glass out.

 

[Pick Holder]

If I was JJP I would of put this modification in all the games from the factory - to a hidden push switch on the back of the backbox. It is beyond me why they did not.