Can anyone shed some light on this.
I had the bottom line out on my Getaway DMD, I soldered it twice but it only lasted an hour or so.
Reading around I did the dremel attack on it carving out the glass to do the link with conductive paint.
When I was working on it I exposed the faulty contact but a small crack had formed into the glass about an inch but would not be noticeable in play.
Connected it all back up but the display is now totally non functional is this what happens when all the gas escapes because I have a horrible feeling this is what I have done.
Any feedback ?
I had the bottom line out on my Getaway DMD, I soldered it twice but it only lasted an hour or so.
Reading around I did the dremel attack on it carving out the glass to do the link with conductive paint.
When I was working on it I exposed the faulty contact but a small crack had formed into the glass about an inch but would not be noticeable in play.
Connected it all back up but the display is now totally non functional is this what happens when all the gas escapes because I have a horrible feeling this is what I have done.
Any feedback ?
