For Sale Eprom Programmer and Eraser

[Paul]

Hi all,
I have had a replacement for a while, however figured that my previous one was gathering dust, so would be better placed in a new home.

Programmer
Model : Wellon VP-280 - http://www.weilei.com/vp-280e.htm
Device support list : http://www.weilei.com/VP-280list.htm
Software : http://www.weilei.com/rj/Disk434.exe

Condition - Few bumps and scrapes, however fully working I'll give it a clean up before it gets sent to the new owner. Comes with USB cable and 12v PSU (says 9v needed, however general advice around the web was suggesting 12v).

Listed as working on anything up to Win7, however works fine on my Win10 machine.

Pics :

Eraser

Standard Generic Mains powered Eprom Eraser. Two pin plug, however comes with one of those ropey 2-3pin adaptors. Does the job. Not much more to say!

Looking for £45 for the pair Posted to mainland UK.

 

[ChrisFormela]

Have you tried to flash old 2732 eeproms with it?

 

[Paul]

I have had success as long as flashed at a low speed with the external PSU connected. As Jim (Mypinballs) says, if you want to do 2732's reguarly then really you should be using a specific programmer built for it (either a very old one - usually parallel port connectivity - OR a Dataman, which is great if you have £500+ to spare).
Most others (27C512's for example) it will flash using just USB power with no external PSU needed.