Wanted Early Bally SS Parts

[DRD]

2x Blue transparent lane guide with 2 sides for fathom/ vector

1x plumb bob with the single screw that goes into the bottom of the lead (later ones have butterfly nuts above and below) for vector

1x rubber bung that sits underneath this square section stainless steel assembly at the rear of the game for the playfield to rest against to keep it level during play for vector

Thank you

 

[carl lawrence]

Which one do you want Dave ?

 

[DRD]

The one on the right please, I don't need the brackets. Just the lead bob, screw and hooked shaft. Can you just check that the thread in the lead is ok, so the wing headed screw does its job

How much would you like for it pls - could you pm me ?

Thanks a lot for digging one out

 

[Nedreud]

Hi @DRD. I don't suppose by the remotest of chances you happen to have a set of 4 red lanes guides that you'd be willing to swap for a set of 4 blue ones? Original Bally ones in good condition just like your top photo.

 

[DRD]

Sorry, but my machines only have the blues so I don't have any reds

 

[Nedreud]

Thanks, @DRD. I know it was a long shot. Might possibly have the blue ones you're after but would need a good set of 4 original red ones to replace them with. Will keep you in mind if something comes up, as it's much nicer to source authentic parts.

 

[paddythegreek]

This wot you're looking for.I only have 1 double and 1 single sided.

 

[DRD]

Hi. I will pm you