Wanted Dotmatrix control board williams for fishtales

[Body pop]

Has anyone got a fully working dotmatrix control board they would sell me for my fishtales ?thanks

 

[Mfresh]

Wasn't Phil at PH selling them cheap a while back?

 

[carl lawrence]

Wasn't Phil at PH selling them cheap a while back?

Think he has sold then all now as they are not showing up on his site !
He does sell the x- pin ones though !

 

[J.C.Rox]

He was moving exclusivelyto Xpin so was selling them cheap, might have one left just not on his site, worth a call to find out..

 

[J.C.Rox]

Now I think about it I part ex ed a faulty dmd board to @lukewells so he might have repaired it and have for sale or he also does board repairs which might prove a cheap solution?

 

[colran65]

Hi, if this is any good for you I have 4 all tested and working. I would let 1 go for you as I really don't need all of them these days.

 

[Body pop]

Sorry I missed some of them posts ,
Just to keep thread right .
I ordered one of the ex pin boards .came yesterday and fitted it ,still the same
Guy from pinball heaven suggested trying a different dotmatrix .so I put my one out of starwars in and all is good again now I need to know can the dot matrix be repaired or has anyone got one forsale .thanks guys

 

[Body pop]

Iv two other problems
Top right hand hole ,the ball gets stuck and when it does a search ,it tries to push it out ,but hasn't enough power
The multiball doesn't register either ,until it does a search or two ,then it sends ball across .
Any help would be greatly appreciated ,as I'm very nearly back to fully working

 

[kevlar]

Sounds like you have a few switch issues, as well as a mechanical issue with the top right hole. Put the machine in switch test and see if the switch in the hole is activated when a ball goes in there.