Hi PinHeads!
I joined here a few years ago when I had TAF and AC/DC as my first two pins....but then had to sell them after 6 months due to circumstances beyond my control
....but just got DOCTOR WHO (thanks Matt for helping to get it upstairs 
)
As a newb, I've replaced from bulbs etc. but noticed that two vertical lines on the DMD on the right hand side are off....but when the 'SECOND CHANCE' graphic flashes...there is a flash of something in those two columns. I'm handy but not an electronics wiz so I pulled out most of the connectors in the backbox going to the DMD and re-seated them but no joy. I even tried applying light pressure on the boards in the hope there was a dry joint or something that might of got connected again (this worked for me years ago when I got hold of Golden Axe for free, 'fixed it' then sold it on eBay).
NOTE: I did accidently apply one of the factory presents when I was learning about the menus etc. maybe there's a config I overwrote?
Any pointers guys?
I joined here a few years ago when I had TAF and AC/DC as my first two pins....but then had to sell them after 6 months due to circumstances beyond my control
....but just got DOCTOR WHO (thanks Matt for helping to get it upstairs )As a newb, I've replaced from bulbs etc. but noticed that two vertical lines on the DMD on the right hand side are off....but when the 'SECOND CHANCE' graphic flashes...there is a flash of something in those two columns. I'm handy but not an electronics wiz so I pulled out most of the connectors in the backbox going to the DMD and re-seated them but no joy. I even tried applying light pressure on the boards in the hope there was a dry joint or something that might of got connected again (this worked for me years ago when I got hold of Golden Axe for free, 'fixed it' then sold it on eBay).
NOTE: I did accidently apply one of the factory presents when I was learning about the menus etc. maybe there's a config I overwrote?
Any pointers guys?
.