Dialed in trap door solution

[Deleted member 2463]

Anyone able to print these?

https://www.thingiverse.com/thing:3851824

 

[Pick Holder]

@Paul the boss man has a 3d printer I believe....

 

[Paul]

Yup - i can rattle both off as a trial... they have a "tight" and a "loose" one... (hence why i said both!) - happy to run one of each off and sent it your way Neil to try out?? Looking at the positioning on the playfield i'll start with PLA, however i can use PETG as a second run if it is successful..

 

[Deleted member 2463]

Sounds good mate. Let me know how much and i’ll send you the dosh.

 

[Paul]

Sounds good mate. Let me know how much and i’ll send you the dosh.

Dont be daft - Lets give it a go first and see if PLA holds up

 

[philpalmer]

Easy fix with no parts used here

 

[Deleted member 2463]

Phil I think mine has that and it still occasionally looses a ball I’ll check later


Sent from my iPhone using Tapatalk Pro

 

[Epotech]

Didn't even know this was a thing. Never had a problem on mine

 

[Darthsinex]

Nor me

 

[kevlar]

Nor mine. ( but I have read it happens plenty of times on pinside )