Wanted Bolts for Stern side rails (near flipper button)

[robotgreg]

Hi

After removing the bolt from the side rail, can see it's a bit buggered which is one of the reasons it was such a pain to remove in the first place. And would only have been like that from factory.

So looking for a replacement (ideally 2 or 3) as could do with some for other machines too.

The bolts are about 2cm long but crucial bit is the head is flat as if you use a domed one, the lockdown bar won't then fit back over the bolt head.

Have tried local ironmongers, B&Q (a vain hope!) and looked on line to no avail. Stern don't seem to list a part number for the bolts either. They also use 3 different types of screw/bolt for the side rails with the ones I'm after only used by the front. The ones near the backbox are domed and usually come up in the search!

Appreciate any help.

Cheers
Greg

 

[J.C.Rox]

Andy usually does that sort of thing @pinballmania

 

[Wayne J]

Have you sourced these yet @robotgreg ? I've still got the ones from when I swapped the side rails off my met.

 

[robotgreg]

Not yet Wayne.

Cheers
Greg

 

[Wayne J]

Assuming these are the ones, pm your address

 

[robotgreg]

That's the ones Wayne, many thanks - very kind. PM sent.

Cheers
Greg

 

[Wayne J]

That's OK, you don't know how much I'm going to charge you for postage!

 

[robotgreg]